Betekenis van:
pa system

Voorbeeldzinnen

1. In the case of a pressure controlled system the remaining error in the control loop must not exceed ± 3 Pa.
2. In the case of a pressure controlled system the remaining error in the control loop must not exceed ± 3 Pa.
3. In the case of a pressure controlled system the remaining error in the control loop must not exceed ± 3 Pa. The pressure oscillations in the dilution tunnel must not exceed ± 250 Pa on average.
4. The pressure of the system is reduced to 133 Pa and the sample is gently warmed until it just boils (removal of dissolved gases).
5. An engine exhaust system or a test laboratory system shall be used presenting an exhaust backpressure within ± 650 Pa of the maximum value specified by the manufacturer at the rated speed and full load.
6. ‘The test engine shall be equipped with an exhaust system with exhaust back pressure within ± 650 Pa of the value specified by the manufacturer at the engine operating conditions resulting in maximum declared power.
7. An engine air intake system must be used presenting an air intake restriction within ± 100 Pa of the upper limit of the engine operating at the speed at the declared maximum power and full load.
8. An engine air intake system shall be used presenting an air intake restriction within ± 100 Pa of the upper limit of the engine operating at the speed at the declared maximum power and full load.
9. An engine air intake system shall be used presenting an air intake restriction within ± 100 Pa of the upper limit of the engine operating at the speed at the declared maximum power and full load.
10. An engine air intake system or a test laboratory system shall be used presenting an air intake restriction within ± 300 Pa of the maximum value specified by the manufacturer for a clean air cleaner at the rated speed and full load.
11. The complete exhaust system shall be fitted as provided for the intended application:Where there is a risk of an appreciable effect on the engine powerIn the case of two-stroke and positive ignition enginesWhen the manufacturer requests that this should be done.In other cases, an equivalent system may be installed provided the pressure measured at the exit of the engine exhaust system does not differ by more than 1000 Pa from that specified by the manufacturer.
12. An exhaust system shall be used presenting an exhaust back pressure within ± 1000 Pa of the upper limit of the engine operating at the speed of declared maximum power and full load and a volume within ± 40 % of that specified by the manufacturer.
13. ‘The test engine shall be equipped with an air inlet system presenting an air inlet restriction within ± 300 Pa of the value specified by the manufacturer for a clean air cleaner at the engine operating conditions as specified by the manufacturer, which result in maximum air flow.
14. An exhaust system must be used presenting an exhaust back pressure within ±1000 Pa of the upper limit of the engine operating at the speed of declared maximum power and full load and a volume within ± 40 per cent of that specified by the manufacturer.
15. An exhaust system shall be used presenting an exhaust back pressure within ±1000 Pa of the upper limit of the engine operating at the speed of declared maximum power and full load and a volume within ± 40 per cent of that specified by the manufacturer.